TucsonDataManu

.com

Hyundai Tucson: Fuel Filler Door

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Fuel Filler Door

Component Location

  1. Fuel filler door release actuator

Inspection

  1. Disconnect the negative (-) battery terminal.
  2. Remove the fuel filler housing after opening the fuel filler door.

    (Refer to Body - "Fuel Filler Door")

  3. Disconnect the connector (A) and then remove tht release actuator (B) after loosening mounting screws.

  1. Check for continuity between terminal No. 1 and No. 2. If there is no continuity, replace the fuel filler door release actuator (A).

Seat Electrical

    READ NEXT:

     Seat Electrical

     Ower Seat Motor

    Component Location Lumber support motor Reclining motor Front height motor Slide motor Rear height motor Lumbar support switch Reclining switch Power seat switch Inspection Ower Seat Motor Remove the front seat assembly.

     Reclining Motor Limit Switch

    Disconnect the limit switch and operate the limit switch and then check for continuity between the terminals. Make sure that the seat operation is normal in the reverse after the maximum operation. If there is an abnormality, replace t

    SEE MORE:

     Smart Cruise Control Settings

    Setting features To turn on the Smart Cruise Control Press the Driving Assist ( ) button to turn on Smart Cruise Control. The speed will be set to the current speed on the cluster.  If there is no vehicle in front of you, the

     Clutch actuator assembly - Components

    Components Fork cover Clutch actuator & TCM assembly Clutch actuator assembly O-ring DCT control module (TCM) Specification Removal Turn ignition switch OFF and disconnect the battery negative (-) terminal. Remove

    Information