TucsonDataManu

.com

Hyundai Tucson: GPF (Gasoline Particulate Filter)

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Intake And Exhaust System / GPF (Gasoline Particulate Filter)

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the floor under cover front RH.
  3. Disconnect the Exhaust Gas Temperature Sensor (EGTS) Front (A) and Rear (B).

  1. Remove the gasoline particulate filter (A).

Tightening torque : 39.2 - 58.8 N.m (4.0 - 6.0 kgf.m, 28.9 - 43.4 lb-ft)

  1. Install in the reverse order of removal.

WARNING

When installing, replace with new gaskets.

Center Muffler/ Rear Muffler

Center Muffler

  1. Remove the center muffler (A)

Tightening torque : 39.2 - 58.8 N.m (4.0 - 6.0 kgf.m, 28.9 - 43.4 lb-ft)

  1. Install in the reverse order of removal.

WARNING

When installing, replace with new gaskets.

Rear Muffler

Remove the rear muffler (A)

Tightening torque : 39.2 - 58.8 N.m (4.0 - 6.0 kgf.m, 28.9 - 43.4 lb-ft)

  1. Install in the reverse order of removal.

WARNING

When installing, replace with new gaskets.

    READ NEXT:

     Lubrication System

     Engine oil flow diagram

    Components Variable oil pump Variable oil pump sproket Oil Pressure & temperature sensor Oil filter Filter cap O-ring Filter cap Safety pin Oil cooler Engine oil flow diagram Replacement WARNING Prolonged and re

     Engine Oil

    Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. Check the engine oil level. After warning up the engine and then 10 minutes after the

    SEE MORE:

     Timing System - Installation

    Keep the liquid gasket sealing surfaces (timing chain cover, cylinder head, cam carrier, cylinder block, lower crankcase) free from foreign matters, cured sealant, oil, dust, moisture and etc. Spray the cleaner on the sealing surface and

     Blower unit assembly

    Components Location Blower unit assembly Components Blower unit assembly Intake actuator Intake duct case LH Intake seal Intake door(l) Intake door(2) Intake duct case RH Climate control actuator PWM blower module B

    Information