Hyundai Tucson: General Information
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / General Information
Troubleshooting
Specifications
Tightening Torque
Special Service Tools
READ NEXT:
Fender
Component Location
Fender assembly
Replacement
WARNING
When removing the fender, wrap protective tape around a
screwdriver or remover not to damage
components
Put on gloves to prevent hand injuries
Remove the front bumper
Hood
Adjustment
After loosening the hinge (A) mounting bolt, adjust the hood (B) by
moving it up and down or from side to side and tighten
the bolt.
Adjust the hood height by moving the hood overslam bumpers (C) up and
down.
After loosenin
SEE MORE:
Power Relay Assembly (PRA) - Removal
Removal
Remove the PRA assembly.
(Refer to 48V Battery System - "Power Relay Assembly (PRA)")
Remove the PRA cover.
Remove the mounting bolts and remove the power relay busbar (A).
Disconnect the main relay connector
Reclining Motor Limit Switch
Disconnect the limit switch and operate the limit switch and then check
for continuity between the
terminals.
Make sure that the seat operation is normal in the reverse after the
maximum operation.
If there is an abnormality, replace t
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
