Hyundai Tucson: Front Muffler
Removal and Installation
- Disconnect the battery negative terminal.
- Disconnect the oxygen sensor connector (A).
- Remove the engine room rear under cover (A).
Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Remove the front muffler (A) after disconnecting the hanger (B).
Tightening torque :
A : 39.2 - 58.8 N.m (4.0 - 6.0 kgf.m, 28.9 - 43.4 lb.ft)
B : 30.4 - 45.1 N.m (3.1 - 4.6 kgf.m, 22.4 - 33.3 lb.ft)
- Install in the reverse order of removal.
WARNING
When installing, replace with new gaskets.
READ NEXT:
GPF (Gasoline Particulate Filter)
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
Remove the floor under cover front RH.
Disconnect the Exhaust Gas Temperature Sensor (EGTS) Front (A) and Rear
(B).
Remove the gasoline particulate fil
Engine oil flow diagram
Components
Variable oil pump
Variable oil pump sproket
Oil Pressure & temperature sensor
Oil filter
Filter cap O-ring
Filter cap
Safety pin
Oil cooler
Engine oil flow diagram
Replacement
WARNING
Prolonged and re
SEE MORE:
Five-step Troubleshooting
Verify the complaint
Turn on all the components in the problem circuit to verify the customer
complaint. Note the
symptoms. Do not begin disassembly or testing until you have narrowed down the
problem area.
Analyze the schematic
Loo
Tire Pressure Monitoring System - Replacement
Remove the tire.
(Refer to Suspension System - "Wheel")
Remove the screw with torx driver (A).
WARNING
When installing the bead brake, make sure that it does not come
in contact with the TPMS sensor.
Be careful no
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
