TucsonDataManu

.com

Hyundai Tucson: Fuel Filler Door

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Fuel Filler Door

Component Location

  1. Fuel filler door

Replacement

Fuel filler door cover

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Open the fuel filler door (A).

  1. Using a flat tip driver (A) unlock the lock pin (B) and then remove the fuel filler door cover (C).

  1. To install, reverse removal procedure.

Fuel filler door assembly

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear wheel guard.

    (Refer to Body Side Molding - "Rear Wheel Guard")

  3. Open the fuel filler door (A).

  1. Open the fuel filler door cap (A) and urea cap (B).

  1. Loosen the mounting nuts, separate the filler neck assembly (A).

  1. Using a screwdriver or remover, remove the fuel filler door assembly (A).

  1. Disconnect the fuel filler door connector (A).

  1. To install, reverse removal procedure.

    READ NEXT:

     Front Door

     Glass Adjustment

    WARNING Check the glass run channel for damage or deterioration, and replace it if necessary. Remove the front door trim. (Refer to Front Door - "Front Door Trim") Lower the glass by operating the power window switch until the gl

     Front door trim

    Component Location Front door trim Replacement WARNING When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries.

    SEE MORE:

     When not using the CVVD fixture

    (3) Remove the CVVD assembly. Remove the Intake CVVT (A). Installation Install the Intake CVVT (A). Install the CVVD assembly (A). WARNING After installing the CVVD, check whether the swing arm is separated

     The Procedure of Manual Tolerance Compensation

    Advanced preparations will be made according to the following. Confirm that the car hood, trunk and door are closed. The door is closed after getting in on the passenger side. Unfold the side mirror if it is folded in. Put the gear int

    Information

    2022-2026 © - www.tucsondatamanu.com