Hyundai Tucson: Front door trim

Component Location

1. Front door trim

Replacement

WARNING

• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.

1. Disconnect the negative (-) battery terminal.
2.  Using a screwdriver or remover, remove the front door quadrant inner cover (A).

3. Disconnect the twitter speaker connector (A).

4. After loosening the mounting screws, remove the lower part of the front door trim (A) using a flat - tip screwdriver.

5. Disconnect the front door inside handle cable (A) and connector (B).

6. Disconnect the connectors (A).

7. Press the lock pin, separate the speaker connector (A).

8. Loosen the mounting screws, remove the hanlde mounting support bracket (A).

9. Disconnect the connectors (A).

10. Remove the front door trim seal (A).

11. To install, reverse the removal procedure.

WARNING

Be sure to replace the clip (fastener) when re-installing after detaching the door trim.

*In case of non-exchange, watertightness / exit problems may occur

Water tightness prevention

• Make sure the connector is connected properly.
• Make sure the door locks / unlocks and opens / closes properly.
• Replace any damaged clips (or pin-type retainers).
• Make sure the glass is operated properly.

Front door trim - Removal

Removal

1. Remove the front door trim.

   (Refer to Front Door - "Front Door Trim")

2. After loosening the mounting screws, remove the front door inside handle (A).

3. To install, reverse removal procedure.

WARNING

Make sure the door locks / unlocks and opens / closes properly.

READ NEXT: