TucsonDataManu

.com

Hyundai Tucson: Front door window glass

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Front Door / Front door window glass

Component Location

  1. Front door window glass

Replacement

  1. Remove the front door trim.

    (Refer to Front Door - "Front Door Trim")

  2. Remove the front door belt inside weatherstrip.

    (Refer to Front Door - "Front Door Belt Inside Weatherstrip")

  3. Remove the front door belt outside weatherstrip.

    (Refer to Front Door - "Front Door Belt outside Weatherstrip")

  4. Lower the glass by operating the power window switch until the glass mounting bolt is exposed in the plug hole.

WARNING

Be careful not to drop the glass and/or scratch the glass surface.

  1. After unscrewing the mounting bolt as loosely as possible and completely loosening the bolt, tilt the front door window glass (A) to pull out it upwards.

Tightening torque : 5.9 - 8.8 N.m (0.6 - 0.9 kgf.m, 4.3 - 6.5 lb-ft)

  1. To install, reverse the removal procedure.

WARNING

  • Make sure that the glass rolls up and down smoothly.
  • Adjust glass position as needed.
  • Make sure the door locks and opens properly.
  • Replace any damaged clips (or pin-type retainers).

    READ NEXT:

     Front door outside handle

    Component Location Front door outside handle Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injurie

     Front Door - Replacement

    Remove the outside rear view mirror. (Refer to Mirror - "Outside Rear View Mirror") Remove the front door belt outside weatherstrip (A). To install, reverse the removal procedure. WARNING Replace any damaged clips (or p

     Front door latch

    Component Location Front door latch Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries.

    SEE MORE:

     Transfer Assembly- Inspection

    Inspection Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") Loosen the oil filler plug (A). A Type B Type Check the oil level. WARNING Oil level must be up to fil

     Heated Steering Wheel Control Module (Integrated Body Control Unit (IBU)

    Turn the ignition switch OFF and disconnect the battery negative (-) cable. Remove the glove box. (Refer to Body - "Glove Box") Remove the heater control unit. (Refer to Heating,Ventilation And Air Conditioning - "Hea

    Information