TucsonDataManu

.com

Hyundai Tucson: Windshield Glass - Replacement

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Windshield Glass / Windshield Glass - Replacement

Components

  1. Windshield glass
  2. Windshield glass upper molding

Replacement

WARNING

Put on gloves to prevent hand injuries.

WARNING

Use seat covers to avoid damaging any surfaces.

  1. Remove the front pillar trim.

    (Refer to Interior Trim - "Front Pillar Trim")

  2. Remove the inside rear view mirror assembly.

    (Refer to Mirror - "Inside Rear View Mirror")

  3. Remove the cowl top cover.

    (Refer to "Cowl Top Cover")

  4. Remove the windshield glass side garnish (A).

  1. Using a cutter knife (A), carefully remove the windshield glass molding.

WARNING

Use the cutter with a 20 to 30 cm-long blade.

  1. Cut off the sealant on the edge (B) while pulling the piano wire (A) to the left and right.

WARNING

  • Heat may occur when working on the wires.
  • Be careful not to burn your hands.
  • Be careful not to disconnect the piano wire.

  1. Put in a piano wire (A) through the corner of the windshield glass and insert wire grips into both ends of the wire.

  1. Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) to the left and right.

WARNING

  • Put on gloves to protect your hands.
  • Heat may occur when working on the wires. Be careful not to burn your hands.
  • Be careful not to disconnect the piano wire.

  1. Remove the windshield glass (B) carefully using the glass holder (A).

Windshield Glass - Installtion

    READ NEXT:

     Windshield Glass - Installtion

    Installtion Using a knife, scrape the remaining sealant around the body panel leaving about 2mm-thick sealant (0.0079 in.) on the bonding surface. If installing a new windshield glass, make alignment marks on the windshield glass and th

     Tail Gate Window Glass

     Tail Gate Window Glass - Removal

    Removal WARNING Put on gloves to prevent hand injuries. WARNING Use seat covers to avoid damaging any surfaces. Remove the tailgate trim. (Refer to Tail Gate - "Tail Gate Trim") Remove the rear spoiler. (Refer to Body Side

    SEE MORE:

     Specifications

    Tightening Torques Special Service Tools Tool (Number and name)/ Illustration/  Use Valve spring compressor (09222-3K000) Valve spring compressor adapter (09222-3K100)/  / Removal and i

     Driver side temperature control actuator / Passenger side temperature control actuator

    Component Location Driver side temperature control actuator Passenger side temperature control actuator Inspection Turn the ignition switch OFF. Disconnect the temperature control actuator connector. Verify that the temperature c

    Information