Hyundai Tucson: Front pillar trim
Component Location
- Front pillar trim
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
WARNING
Take care not to bend or scratch the trim and panels.
- Remove the front pillar trim.
(1) To remove the front pillar trim, the fastener remover (A) below must be
used. 
(2) After slightly lifting up the front pillar trim and putting the tool in, remove the mounting clip (A) by pulling it.
WARNING
Once the front pillar trim is removed, be sure to replace the clips
with new ones. 
(3) Remove the front pillar trim (A).
- To install, reverse removal procedure.
WARNING
Replace any damaged clips (or pin-type retainers).
READ NEXT:
Center pillar trim
Component Location
Center pillar lower trim
Center pillar upper trim
Replacement
Center pillar lower trim
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to prevent
damage to
Rear pillar trim
Component Location
Rear pillar trim
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
WAR
Trunk Trim
Components
Luggage tray
Wheel house pad
Luggage side trim
Rear transverse trim
Cargo screen
Luggage board
SEE MORE:
Smart Cruise Control Settings
Setting features
To turn on the Smart Cruise Control
Press the Driving Assist ( ) button
to turn on Smart Cruise Control. The
speed will be set to the current speed
on the cluster.
If there is no vehicle in front of you,
the
Engine coolant
The high-pressure cooling system has a
reservoir filled with year-round antifreeze
coolant. The reservoir is filled at the
factory.
Check the antifreeze protection and
coolant level at least once a year, at
the beginning of the winter season
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
