Hyundai Tucson: Outside rear view mirror
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Mirror / Outside rear view mirror
Component Location

- Outside rear view mirror
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
- Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
- Press the lock pin, separate the outside rear view mirror connector (A).

- Loosen the mounting bolts and clip, remove the outside rear view mirror (A).
Tightening torque : 6.9 - 10.8 N.m (0.7 - l.lkgf.m , 5.1 - 8.0 lb-ft)

- To install, reverse removal procedure.
WARNING
Make sure the connector is connected properly.
READ NEXT:
Inside rear view mirror
Component Location
Inside rear view mirror
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
Cowl Top Cover
Component Location
Cowl Top Cover
Replacement
Remove the cap and the nuts, and then remove the wiper arm (A).
Tightening torque :
22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)
Disconnect the washer nozzle (A).
SEE MORE:
Air cleaner
Filter replacement
The air cleaner filter can be cleaned for
inspection using compressed air. Do not
attempt to wash or to rinse it, as water
will damage the filter. If soiled, the air
cleaner filter must be replaced.
Pull up the air
Ambient Temperature Sensor (ATS)
Description
Ambient Temperature Sensor (ATS) is installed on the front-end module and
senses the ambient
temperature.
This sensor is exposed to the ambient air temperature in front of the radiator.
The ATS is a Negative Temperature Coeffici
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual