Hyundai Tucson: Crash Pad
Components
- Crash pad side cover LH
- Crash pad lower panel
- Crash pad assembly
- Crash pad side cover RH
- Supervision cluster
- Crash pad lower panel
- Glove box
- Crash pad air vent
- Crash pad side cover
- Crash pad center panel
- Main crash pad assembly
- Cowl cross bar assembly
READ NEXT:
Supervision cluster
Component Location
Cluster fascia panel
General cluster
Cluster fascia panel
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Crash pad lower panel
Component
Location
Crash pad lower panel
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
Glove box
Component Location
Glove box
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
WARNING
Tak
SEE MORE:
SRSCM - Installation
Installation
Install in the reverse of the removal.
After installing the SRSCM, confirm proper system operation.
WARNING
SIf the Switch ON the ignition, the SRS indicator light should turn
on for about six seconds and then off.
Variant
Rear door trim
Component Location
Rear door trim
Replacement
WARNING
When removing with a flat - tip screwdriver or remover, wrap
protective tape around the tools
to prevent damage to components.
Put on gloves to prevent hand injuries.
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
