Hyundai Tucson: General Information
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Suspension System / General Information
Troubleshooting
Wheel and tire diagnosis
Rapid wear at the center
- Center-tread down to fabric due to excessive over inflated tires
- Lack of rotation
- Excessive toe on drive wheels
- Heavy acceleration on drive
Rapid wear at both shoulders
- Under-inflated tires
- Worn suspension components
- Excessive cornering speeds
- Lack of rotation
Wear at one shoulder
- Toe adjustment out of specification
- Camber out of specification
- Damaged strut
- Damaged lower arm
Partial wear
- Caused by irregular burrs on brake drums
Feathered edge
- Toe adjustment out of specification
- Damaged or worn tie rods
- Damaged knuckle
Wear pattern
- Excessive toe on non-drive wheels
- Lack of rotation
Specifications
Front Suspension
Rear Suspension
Wheel & Tire
Wheel Alignment
Tightening Torque
Front Suspension
Rear Suspension
Special Service Tools
Tool (Number and Name)/ Illustration/ Use
0K546-F6100
Shock absorber lock
nut removal tool/
/ Used for remove the front
shock absorber lock nut
09546-3X100
Shock absorber lock
nut removal tool/
/ Used for remove the rear
shock absorber lock nut
09568-1S100
Ball joint remover/
/ Removal of the tie rod end
ball joint.
09568-4R100
Lower arm ball joint
remover/ 
/
Removal of the lower arm
ball joint.
READ NEXT:
Front Suspension System
Components Location
Front sub frame
Steering gear box
Front stabilizer bar
Front lower arm
Front knuckle assembly
Components
Stmt assembly
Spring lower pad
Dust cover
Coil spring
Spring upper pad
Bumper rubber
I
Front Suspension System- Removal
Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage the
lower parts of the vehicle (floor under
cover, fuel filter, fuel tank, canister).
(Refer to General Information - "Lift Point")
Loosen the front w
Front Suspension System- Disassembly
WARNING
When compressing the coil spring, be cautious as there may be
corrosion due to damage to the coil
spring painting.
In order to avoid such painting damage, compress by putting over the waste hose,
etc. (Refer to the
picture below.)
SEE MORE:
Rear wheel speed sensor- Replacement
Replacement
Remove the rear wheel hub bearing assembly.
(Refer to Drivesliaft and Axle - "Rear Hub - Carrier")
Fix the rear hub bearing assembly (A) on the vise.
WARNING
When fixing on the vise, use a cloth not to be damaged
Driveshaft side oil seal #3 B Typel
Remove the transfer assembly.
(Refer to 4 Wheel Drive (4WD) System - "Front Wheel Transfer Assembly")
Remove the dust cover (A).
Remove the oil seal #2 (A).
Remove the oil seal #3 (A).
Install the oil
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
