TucsonDataManu

.com

Hyundai Tucson: Front Suspension System

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Suspension System / Front Suspension System

Components Location

Front sub frame
Steering gear box
Front stabilizer bar
Front lower arm
Front knuckle assembly

Components

Stmt assembly
Spring lower pad
Dust cover
Coil spring
Spring upper pad
Bumper rubber
Insulator assembly & sturt bearing
Lock nut
Insulator cap

Front Suspension System- Removal

Removal WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister). (Refer to General Information - "Lift Point") Loosen the front w

Front Suspension System- Disassembly

WARNING When compressing the coil spring, be cautious as there may be corrosion due to damage to the coil spring painting. In order to avoid such painting damage, compress by putting over the waste hose, etc. (Refer to the picture below.)

Front Suspension System- Replacement

Replacement WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister). (Refer to General Information - "Lift Point") Loosen the fro

SEE MORE:

Fuel Pressure Control Valve (FPCV)

Description Installed on the high pressure fuel pump, the Fuel Pressure Regulator Valve controls the fuel amount flowing into the injectors in accordance with the ECM signal calculated based on various engine conditions. Specification

IMT System Actuator- Installation

Installation Install the IMT system actuator (A) and then tightening the bolts. Tightening torque: 19.6 - 26.5 N.m (2.0 - 2.7 kgf.m. 14.5 - 19.5 lb-ft) Lightly install the concentric slave cylinder (B) on the input shaft (A).