Hyundai Tucson: Suspension System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Suspension System
- General Information
- Front Suspension System
- Front Suspension System- Removal
- Front Suspension System- Disassembly
- Front Suspension System- Replacement
- Rear Suspension System
- Tires_Wheels
- Tire Pressure Monitoring System
- TREAD Lamp
- Tire Pressure Monitoring System - Replacement
- Diagnostic Procedure Using a Diagnostic
- TPMS Receiver : BCM(body control module) integrated management
- ECS (Electronic Control Suspension) System
READ NEXT:
General Information
Troubleshooting
Wheel and tire diagnosis
Rapid wear at the center
Center-tread down to fabric due to
excessive over inflated tires
Lack of rotation
Excessive toe on drive wheels
Heavy acceleration on drive
Rapid wear at both sh
Front Suspension System
Components Location
Front sub frame
Steering gear box
Front stabilizer bar
Front lower arm
Front knuckle assembly
Components
Stmt assembly
Spring lower pad
Dust cover
Coil spring
Spring upper pad
Bumper rubber
I
Front Suspension System- Removal
Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage the
lower parts of the vehicle (floor under
cover, fuel filter, fuel tank, canister).
(Refer to General Information - "Lift Point")
Loosen the front w
SEE MORE:
When not using the CVVD fixture
(3) Remove the CVVD assembly.
Remove the Intake CVVT (A).
Installation
Install the Intake CVVT (A).
Install the CVVD assembly (A).
WARNING
After installing the CVVD, check whether the swing arm is
separated
Rear Outside Combination Lamp
Disconnect the negative (-) battery terminal.
Loosen the mounting bolts then remove the outside rear combination lamp
(A).
Disconnect the rear combination lamp connector (A).
Remove the bulb after turning it in the counter
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
