Hyundai Tucson: Tire Pressure Monitoring System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Suspension System / Tire Pressure Monitoring System
- TREAD Lamp
- Tire Pressure Monitoring System - Replacement
- Diagnostic Procedure Using a Diagnostic
- TPMS Receiver : BCM(body control module) integrated management
READ NEXT:
TREAD Lamp
Tire Under Inflation / Leak Warning.
Turn on condition
When tire pressure is below allowed threshold
When rapid leak is detected by the sensor.
Indicates that tire needs to be re-inflated to placard pressure /
repaired.
Tire Pressure Monitoring System - Replacement
Remove the tire.
(Refer to Suspension System - "Wheel")
Remove the screw with torx driver (A).
WARNING
When installing the bead brake, make sure that it does not come
in contact with the TPMS sensor.
Be careful no
Diagnostic Procedure Using a Diagnostic
Instrument
The following section describes how to diagnose faults using a diagnostic
instrument.
Connect the diagnostic instalment to the self-diagnostic connector
(16-pin) beneath the crash pad on the side of driver's
seat, and then
SEE MORE:
Multifunction Switch Inspection
Check for continuity between the terminals in each switch position as
shown below.
Inspection (With Diagnostic Tool)
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (d
DCT (Dual Clutch Transmission) System (SBW)
Troubleshooting
Specifications
Clutch Actuator
Gear Actuator
Inhibitor Switch
Type: Combination of output signals from 4 terminals
Specifications
Input speed sensor
Tightening Torques
Lubricants
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
