Hyundai Tucson: Rear Suspension System - Components
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Suspension System / Rear Suspension System / Rear Suspension System - Components
Components
2WD
- Rear shock absorber
- Rear lower arm
- Rear stabilizer bar
- Rear sub frame
- Rear upper arm
- Rear assist arm
- Trailing arm
4WD
- Rear shock absorber
- Rear lower arm
- Rear stabilizer bar
- Rear differential carrier
- Rear sub frame
- Rear driveshaft
- Rear upper arm
- Trailing arm
READ NEXT:
Rear shock absorber
Components
Lock nut
Insulator assembly
Dust cover
Rear shock absorber
Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage the
lower parts of the vehicle (floor under
cover, fuel filter, fuel tank, canis
Rear Suspension System - Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage the
lower parts of the vehicle (floor under
cover, fuel filter, fuel tank, canister).
(Refer to General Information - "Lift Point")
Loosen the rear wheel nuts
SEE MORE:
Piston Rings
Inspect the piston ring side clearance.
Using a feeler gauge, measure the clearance between new piston ring and the
wall of ring groove.
Piston ring groove width dimension of piston
No.1 ring : 1.230 - 1.250 mm (0.0484 - 0.0492 in.)
No.2 r
Knock Sensor (KS)
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine
damage.
Knock Sensor (KS) is installed on the cylinder block and senses engine knocking.
When knocking
occurs, the vibration from the
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
