Hyundai Tucson: Rear transverse trim
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Trunk Trim / Rear transverse trim
Component Location
- Rear transverse trim
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
WARNING
Take care not to bend or scratch the trim and panels.
- Remove the tailgate weatherstrip.
(Refer to Tail Gate - "Tail Gate Weatherstrip")
- Remove the luggage board (A).
- Remove the luggate tray (A).
- Remove the rear transverse trim (A).
- To install, reverse removal procedure.
WARNING
Replace any damaged clips (or pin-type retainers).
READ NEXT:
Luggage side trim
Component Location
Luggage side trim
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
WA
Windshield Glass - Replacement
Components
Windshield glass
Windshield glass upper molding
Replacement
WARNING
Put on gloves to prevent hand injuries.
WARNING
Use seat covers to avoid damaging any surfaces.
Remove the front pillar trim.
(Refer to Interior Tri
SEE MORE:
Forward Collision-Avoidance Assist Settings
Setting features
Forward Safety
With the engine on, select 'Driver
Assistance → Forward Safety' from the
Settings menu to set whether or not to
use each function.
If 'Active Assist' is selected, Forward
Collision-Avoidance Assis
Jump starting
Jump starting can be dangerous if done
incorrectly. Follow the jump starting
procedure in this section to avoid serious
injury or damage to your vehicle. If in
doubt about how to properly jump start
your vehicle, we strongly recommend
that you
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
