Hyundai Tucson: Panorama Sunroof - Replacement

1. Open movable glass completely pressing panorama sunroof switch.
2. Remove the decoration cover (A).

3. Close movable glass completely pressing panorama sunroof switch .
4. Loosen the height adjustment releasing screw (A).

WARNING

Be careful not to damage screws.

5. Remove the movable glass (A).

WARNING

Be careful not to damage movable glass.

6. To install, reverse the removal procedure.

WARNING

Carry out considerable step adjustment after exchanging movable glass.

Removal

WARNING

• In order to remove the front glass, use the tools shown in the following figure:

Tooling Diagram

1. Square wire
2. Insert-type wire grip

• Insert and affix square wire (1) into the insert hole of the wire grip (2).

Tooling Assembly Diagram

1. Press panorama sunroof switch to fully open the movable glass.
2. Remove the roof side molding (A).

3. Pull the square wire (A) to the left and right, then apply a force in the direction of the arrow to cut off the residual sealant.

WARNING

Longer wires require more power, so divide Section © and © in half to cut off residual sealant.

WARNING

• Make sure that you put on gloves to protect your hands from potential injury.
• Be careful about potentially burning your hands due to the heat generated from the wire in use.
• Be careful when working with wiring because it may be cut.

WARNING

Be careful not to damage the body.

4. Remove the front glass (A) carefully without damaging it.

Replacement

1. Open movable glass completely pressing panorama sunroof switch.
2. Loosen the panorama sunroof deflector mounting screws and remove the bracket (A).

3. Separate the panorama sunroof deflector link (A) and remove the panorama sunroof deflector (B).

4. To install, reverse the removal procedure.

Replacement

1. Remove the roof trim.

   (Refer to Roof Trim - "Roof Trim Assembly")

2. Remove the movable glass.

   (Refer to Panorama Sunroof - "Movable Glass")

3. Remove the panorama sunroof deflector.

   (Refer to Panorama Sunroof - "Panorama Sunroof Deflector")

4. Remove the glass motor (B) and roller blind motor (A) loosening mounting screws.

5. Loosen the mounting bolts and nuts, remove the mechanism assembly (A).

6. To install, reverse the removal procedure.

WARNING

Make sure the connectors are connected in properly.

READ NEXT: