TucsonDataManu

.com

Hyundai Tucson: Cylinder Block - Components

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Cylinder Block / Cylinder Block - Components

  1. Cylinder block
  2. Water jacket insert (Exhaust)
  3. Water jacket insert (Intake)
  4. Lower crankcase
  5. Oil jet
  6. O-ring

  1. Piston ring (No.1 ring
  2. Piston ring (No.2 ring)
  3. Piston ring(Oil ring)
  4. Piston
  5. Piston
  6. snap ring
  7. Connecting rod upper bearing
  8. Connecting rod lower bearing
  9. Connecting rod
  10. Connecting rod bearing cap
  11. Crankshaft damper pulley
  12. Crankshaft
  13. Crankshaft position sensor wheel
  14. Flywheel
  15.  Crankshaft upper bearing(No.1 and No.3, No.5 journal)
  16. Crankshaft upper bearing(No.2 and No.4)
  17. Crankshaft lower bearing
  18. Crankshaft thrust bearing
  19. Pilot bearing (DCT only)

Components

  1. LH Water jacket insert
  2. RH Water jacket insert

    READ NEXT:

     Cylinder Block - Removal and Installation

    Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head") Remove the RH water jacket insert and LH water jacket insert (A). WARNING When removing the water jacket insert, Be careful not to damage the

     Cylinder Block - Replacement

    Components Rear oil seal Replacement Remove the fly wheel. (Refer to Cylinder Block - "Fly Wheel") Remove the rear oil seal (A). Apply engine oil on the edge of new rear oil seal. Using SSTs (09231-H1100, 09231

     Cylinder Block - Disassembly

    WARNING Use fender covers to avoid damaging painted surfaces. To avoid damage, unplug the wiring connectors carefully while holding the connector portion. WARNING Mark all wiring connector and hoses to avoid misconnection. To releas

    SEE MORE:

     Indicators And Gauges

    Troubleshooting Description Cluster Variant Coding As we have more options (SCC, VDC, EPB, Cubis, MDPS, TPMS. LDWS, ECS -) in the car, the dashboard now has more information to display depending on the chosen options. For this reason, we

     48V Battery System -  Repair procedures (Removal)

    Turn ignition switch OFF and disconnect the battery (-) terminal. Remove the 48V battery assembly. (Refer to 48V Battery System - "Repair procedures") Remove the battery cover (A) after loosening the mounting bolts. Tightenin

    Information

    2022-2026 © - www.tucsondatamanu.com