TucsonDataManu

.com

Hyundai Tucson: Door Outside Handle

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Smart Key System / Door Outside Handle

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Remove the door outside handle cover (A)

  1. Remove the plug hole (A.

  1. Loosen the mounting bolt (A).

  1. Remove the front door lock assembly (A).

  1. Remove the front door outside handle (A) by sliding it forward.

  1. Disconnect the front door outside handle connector (A).

Installation

Installation

Interior 1 Antenna

  1. Install the interior 1 antenna.
  2. Install the ecall unit.
  3. Install the negative (-) batteiy terminal and check the smart key system.

Interior 2 Antenna

  1. Install the interior 2 antenna.
  2. Install the console rear complete assembly.
  3. Install the negative (-) batteiy terminal and check the smart key system.

Tailgate Antenna

  1. Install the tailgate Antenna.
  2. Install the rear transverse trim.
  3. Install the luggage floor tray.
  4. Install the luggage mat.
  5. Install the negative (-) batteiy terminal and check the smart key system.

Exterior Bumper Antenna

  1. Install the exterior bumper antenna.
  2. Install the rear bumper assembly.
  3. Install the negative (-) batteiy terminal and check the smart key system.

Door Outside Handle

  1. Install the outside handle.
  2. Install the front door trim.
  3. Install the negative (-) batteiy terminal and check the smart key system.

Tailgate Open Switch

  1. Install the tailgate open switch.
  2. Install the tailgate back panel molding.
  3. Install the negative (-) batteiy terminal and check the smart key system.

Door Antenna

  1. Install the door antenna.
  2. Install the front door trim.
  3. Install the negative (-) batteiy terminal and check the smart key system.

Front Antenna

  1. Install the front antenna.
  2. Install the front bumper assembly.
  3. Install the negative (-) batteiy terminal and check the smart key system.

    READ NEXT:

     Keyless Entry And Burglar Alarm

    Description Burglar Alarm State (B/A State) Remark: On Smart key system, it works the same way with passive lock Remark: On Smart key system, it works the same way with passive unlock Remark: On Smart key system, it works

     Integrated Body Control Unit (IBU)

     Body Control Module Controls The Followings

    Description Body Control Module Controls The Followings Wiper & Washer Control Defroster Control Driving Control Tailgate Control Window Control Interior Control Exterior Control Panic alarm Control MTS Flasher output Contr

    SEE MORE:

     Roll rod bracket

    Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Remove the roll rod bracket (A). Tightening torque : Bolt (B): 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

     Cylinder Head Assembly - Removal

    Disconnect the battery negative terminal. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover") Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleane

    Information

    2022-2026 © - www.tucsondatamanu.com