TucsonDataManu

.com

Hyundai Tucson: Keyless Entry And Burglar Alarm

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Keyless Entry And Burglar Alarm

Description

Burglar Alarm State (B/A State)

Remark: On Smart key system, it works the same way with passive lock

Remark: On Smart key system, it works the same way with passive lock

Remark: On Smart key system, it works the same way with passive unlock

Remark: On Smart key system, it works the same way with passive unlock

Remark: On Smart key system, it works the same way with passive unlock

Remark: On Smart key system, it works the same way with passive unlock

Specification

Specification

Inspection

Inspection

Front Door Lock Module Inspection

  1. Remove the front door trim.

    (Refer to Body - "Front Door Trim")

  2. Disconnect the connectors from the actuator.
  3. Check actuator operation by connecting power and ground according to the table.

Rear Door Lock Module Inspection

Rear Door Lock Module Inspection

  1. Remove the rear door trim.

    (Refer to Body - "Rear Door Trim")

  2. Disconnect the connectors from the actuator.
  3. Check actuator operation by connecting power and ground according to the table.

Tailgate Lock Module Inspection

Tailgate Lock Module Inspection

  1. Remove the tailgate trim.

    (Refer to Body - "Tail Gate Trim")

  2. Disconnect the connector from the actuator.

  1. Check actuator operation by connecting power and ground according to the table.

Hood Switch

Hood Switch

  1. Disconnect the connector and bolts from the hood switch.

  1. Check for continuity between the terminals and ground according to the table.

    READ NEXT:

     Integrated Body Control Unit (IBU)

     Body Control Module Controls The Followings

    Description Body Control Module Controls The Followings Wiper & Washer Control Defroster Control Driving Control Tailgate Control Window Control Interior Control Exterior Control Panic alarm Control MTS Flasher output Contr

     IBU Diagnosis With Diagnostic Tool

    In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system. (1) Fault Code Searching : Checking failure and code number (DTC) (2) Data Analysis : Checking the system input/output data state (3) A

    SEE MORE:

     Rear Door Trim - Replacement

    Pull down the rear door window glass to the lowest level by pressing the power window glass switch. Remove the rear door belt outside weatherstrip (A). To install, reverse the removal procedure. WARNING Replace any damaged cli

     General Information

    Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries. Except when performing

    Information