TucsonDataManu

.com

Hyundai Tucson: Cylinder Block

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Cylinder Block

Cylinder Block - Components

Cylinder block Water jacket insert (Exhaust) Water jacket insert (Intake) Lower crankcase Oil jet O-ring Piston ring (No.1 ring Piston ring (No.2 ring) Piston ring(Oil ring) Piston Piston snap ring

Cylinder Block - Removal and Installation

Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head") Remove the RH water jacket insert and LH water jacket insert (A). WARNING When removing the water jacket insert, Be careful not to damage the

Cylinder Block - Replacement

Components Rear oil seal Replacement Remove the fly wheel. (Refer to Cylinder Block - "Fly Wheel") Remove the rear oil seal (A). Apply engine oil on the edge of new rear oil seal. Using SSTs (09231-H1100, 09231

SEE MORE:

Rear transverse trim

Component Location Rear transverse trim Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries.

Rear wheel speed sensor- Replacement

Replacement Remove the rear wheel hub bearing assembly. (Refer to Drivesliaft and Axle - "Rear Hub - Carrier") Fix the rear hub bearing assembly (A) on the vise. WARNING When fixing on the vise, use a cloth not to be damaged