Hyundai Tucson: Brake System
- General Information
- Braking System - operation and description
- Operation and Leakage Check
- Brake Booster Operating
- Brake Booster - Removal
- Brake Tube Engine Room
- Brake Tube- Replacement
- Front Brake Caliper
- Front Brake Disc
- Rear Brake Caliper
- Rear Brake Disc
- Front Brake Pad
- Rear Brake Pad
- Brake Pedal
- Brake Pedal - Removal
- Parking Brake System
- Parking Brake Pedal Stroke
- Parking Brake Adjustment
- Lever Type
- Pedal Type
- Main Function
- Electronic Parking Brake (EPB)
- ESC (Electronic Stability Control) System
- Description of ESP
- Warning Lamp Control( ABS/EBD)
- Electronic Stability Control System- Components
- ABS Does Not Operate/ ABS Does Not Operate (Intermittently)
- When Ignition Key Is Turned ON (engine OFF), The ABS Warning Lamp Does Not Light Up.
- Even After The Engine Is Started, The ABS Warning Lamp Remains ON
- ESC Control unit (HECU)
- ESC Control unit (HECU) - Adjustment
- Front wheel speed sensor/ Front wheel speed sensor connector
- Rear wheel speed sensor
- Rear wheel speed sensor- Replacement
- Rear wheel speed sensor - Inspection
- Introduction of Quick Brake Warning System (ESS)
READ NEXT:
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of the problem. The numbers
indicate the priority of the
likely cause of the problem.
Check each part in order.
If necessary, replace these parts.
Specificat
ESC Bleeding of Brake System
This procedure should be followed to ensure adequate bleeding of air and
filling of the ESC unit, brake lines and master cylinder
with brake fluid.
Connect the brake fluid filler to the reservoir tank.
WARNING
Do not reuse the drained f
SEE MORE:
Operation for each function of button starting
Electric power ON / Ignition ON
The electric power state changes within the range of OFF ->ACC->IGN->OFF
by pressing the button without stepping on
the brake (Or with stepping on the brake) inside the car with FOB key (However.
Measuring the resistance of the pressure sensor
Turn ignition switch OFF.
Disconnect the pressure sensor connector.
Measure resistance between sensor terminal and terminal.
Check the measured resistance. (Refer to table)
Table 1
Removal
Remove the coupling assembly.
(Refer to
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
