Hyundai Tucson: Braking System - operation and description
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Brake System / Braking System - operation and description
- Operation and Leakage Check
- Brake Booster Operating
- Brake Booster - Removal
- Brake Tube Engine Room
- Brake Tube- Replacement
- Front Brake Caliper
- Front Brake Disc
- Rear Brake Caliper
- Rear Brake Disc
- Front Brake Pad
- Rear Brake Pad
- Brake Pedal
- Brake Pedal - Removal
READ NEXT:
Operation and Leakage Check
Inspection
Brake Booster (A)
(1) Check brake operation by applying the brakes during a test drive. If the
brakes do not work properly, check the brake
booster. Replace the brake booster as an assembly if it does not work properly
or i
Brake Booster Operating
Components
Reservoir cap
Reservoir
Brake booster
Master cylinder
Push rod
Test
Run the engine for one or two minutes, and then stop it. If the pedal
depresses fully the first time but
gradually becomes higher when depressed
Brake Booster - Removal
Components
Reservoir cap
Reservoir
Brake booster
Master cylinder
Push rod
Removal
Turm ignition switch OFF and disconnect the negative (-) battery cable.
Remove the battery.
(Refer to Engine Electrical System - "Batter
SEE MORE:
Roll rod bracket
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
Remove the roll rod bracket (A).
Tightening torque :
Bolt (B): 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
Immobilizer System - Removal
Removal
Disconnect the negative (-) battery terminal.
Remove the heater control unit.
(Refer to Heating,Ventilation And Air Conditioning - "Heater Control Unit")
Loosen the mounting bolt,nut,screw and remove the Integrated Body
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
