Hyundai Tucson: Engine Electrical System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Electrical System
- 48V Battery System
- 48V Battery System - Description
- 48V Battery System - Removal
- 48V Battery System - Repair procedures (Removal)
- BMS ECU Terminal and Input/Output Signal
- Power Relay Assembly (PRA) - Removal
- Battery Pack Assembly Inlet Duct/ Battery Pack Assembly Outlet Duct
- Battery Module Inlet Duct
- Battery Module Inlet B Duct
- Engine Room Under Cover
- Engine Mechanical System
- Charging System
- Vehicle parasitic current inspection
- CMF Battery
- Battery
- Battery Condition - Vehicle parasitic current inspection
- Battery Test Procedure
- Charge and Retest method after battery charge
- The MDX-670P Analyzer
- Charge and Retest method after battery charge
- Charging System - Cleaning
- Ignition System
- Ignition System - Description
- On-vehicle- Inspection
- Connector assembly status test- Troubleshooting
- Engine Cover
- On vehicle inspection
- Specifications
- Starting System
READ NEXT:
48V Battery System - Description
Description
The Mild Hybrid Electric Vehicle (MHEV) uses hybrid power source (Engine,
MHSG), so its fuel efficiency is relatively high
and exhaust emission is very small compared to the traditional vehicle which
uses only engine as power source
48V Battery System - Removal
Turn the ignition switch OFF and disconnect the battery (-) terminal.
Remove the luggage board (A).
Disconnect the BMS ECU extension wiring harness connector (A).
Disconnect the inverter power cables (A).
Tightening torque
SEE MORE:
Electric Exhaust Gas Re-circulation (EEGR) Control Valve
Description
The Electric EGR Control Valve is installed in between the EGR cooler and the
exhaust line and is a
solenoid valve. This valve controls EGR (Exhaust Gas Recirculation) amount by
the ECM's duty
control signal depending on engine
Knock Sensor (KS)
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine
damage.
Knock Sensor (KS) is installed on the cylinder block and senses engine knocking.
When knocking
occurs, the vibration from the
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
