Hyundai Tucson: Battery Module Inlet Duct
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Electrical System / 48V Battery System / Battery Module Inlet Duct
- Turn ignition switch OFF and disconnect the battery (-) terminal.
- Remove the 48V battery assembly
(Refer to 48V Battery System - "Repair procedures")
- Remove the battery cover (A) after loosening the mounting bolts.
Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Remove the terminal capacitor (A) after loosening the mounting bolts.
Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Remove the mounting nuts and remove the battery module (-) busbar (A).
Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Remove the mounting nuts and remove the battery module (+) busbar (A).
Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Remove the BMS wiring harness terminal after loosening the mounting bolts (A).
Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
- Remove the battery case assembly.
- Remove the battety module lnlet duct (A) after loosening mountin bolts.
Tightening torque : 3.4 - 6.4 N.m (0.35 - 0.65 kgf.m, 2.5 - 4.7 lb-ft)
- Install in the reverse order of removal.
READ NEXT:
Battery Module Inlet B Duct
Remove the 48V battery assembly.
(Refer to 48V Battery System - "Repair procedures")
Remove the battery pack assembly inlet duct B (A) after loosening the
mounting bolts.
Install in the reverse order of removal.
Sp
Engine Room Under Cover
Removal
Turn the ignition switch OFF and disconnect the battery (-) terminal.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Disconnect the ground cable (A).
Tightening to
Engine Mechanical System
Components
Pulley
Stator assembly
Rotor assembly
Brush holder assembly
Front bracket assembly
Rear bracket assembly
Inverter assembly
Removal
Turn the ignition switch OFF and disconnect the battery (-) terminal.
Disconnec
SEE MORE:
Rear bumper beam assembly
Component
Location
Rear bumper beam assembly
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuri
Knock Sensor (KS)
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine
damage.
Knock Sensor (KS) is installed on the cylinder block and senses engine knocking.
When knocking
occurs, the vibration from the
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
