TucsonDataManu

.com

Hyundai Tucson: CMF Battery

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Electrical System / Charging System / CMF Battery

Description

The CMF (Closed Maintenance Free) battery is, as the name implies, totally maintenance free and has no removable battery cell caps.

The CMF (Closed Maintenance Free) battery does not require water replenishment for the repair.

The battery is completely sealed, except for small vent holes in the cover.

CMF60L

WARNING

WARNING

After disconnecting then reconnecting the battery negative cable, reset some parts that require the reset procedures.

(Refer to Body Electrical System - "General Information")

Specification

CMF60L-DIN

Model type description

Model type description

Cold Cranking Ampere (CCA) : A rating used in the battery industry to define

Cold Cranking Ampere (CCA) : A rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.

  • The rating is the number of amps a new, fully charged battery can deliver at -18ºC (-0.4ºF) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
  • The higher the CCA rating, the greater the starting power of the battery.

RESERVE CAPACITY (RC) : A battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.

  • The rating is the number of minutes a battery at 26.7ºC (80ºF) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
  • The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.

BCI Type

DIN Type

DIN Type

AGM DIN Type

AGM DIN Type

Battery

    READ NEXT:

     Battery

    Removal Turn the ignition switch OFF and disconnect the battery (-) terminal (A). Tightening torque : 7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 Ib-ft) Disconnect the battery (+) terminal (A). Tightening torque : 7.8 - 9.8 N.m (0.

     Battery Condition - Vehicle parasitic current inspection

    Inspection Check the battery for damage or deformation. If severe damage, deformation or leakage is found, replace the battery. Using the Ammeter Turn the all electric devices OFF, and then turn the ignition switch OFF. Close all doors exc

     Battery Test Procedure

    Connect the tester to the battery. Red clamp to battery positive (+) terminal. Black clamp to battery negative (-) terminal WARNING Connect clamps securely. If "CHECK CONNECTION" message is displayed on the screen, reco

    SEE MORE:

     System Interface

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone

     Engine mounting bracket

    Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Install the jack to the edge of oil pan. WARNING Insert the rubber block between jack and oil pan. Remove the eng

    Information

    2022-2026 © - www.tucsondatamanu.com