TucsonDataManu

.com

Hyundai Tucson: Active Air Flap (AAF) Actuator

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Cooling System / Active Air Flap (AAF) Actuator

Remove the front bumper.
(Refer to Body (Interior and Exterior) - "Front Bumper Cover")
Disconnect the active air flap connector (A).

Remove the active air flap actuator (A) after loosening the mounting screws.

Install in the reverse order of removal.

Cylinder Block - Components

Cylinder block Water jacket insert (Exhaust) Water jacket insert (Intake) Lower crankcase Oil jet O-ring Piston ring (No.1 ring Piston ring (No.2 ring) Piston ring(Oil ring) Piston Piston snap ring

Cylinder Block - Removal and Installation

Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head") Remove the RH water jacket insert and LH water jacket insert (A). WARNING When removing the water jacket insert, Be careful not to damage the

SEE MORE:

Inhibitor switch/ Manual control lever- Removal

Turn ignition switch OFF and disconnect the batteiy negative (-) terminal. Make sure vehicle does not roll before setting shift lever to "N" position. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical

Clutch Master Cylinder

Components Clutch pedal arm Clutch master cylinder Clutch pedal assembly Removal Remove the clutch pedal. (Refer to Clutch System - "Clutch Pedal") Remove the clip (A). Remove the push rod pin (A) by push