TucsonDataManu

.com

Hyundai Tucson: Active Air Flap(AAF)

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Cooling System / Active Air Flap(AAF)

Remove the front bumper.
(Refer to Body (Interior and Exterior) - "Front Bumper Cover")
Disconnect the active air flap connector (A).

Remove the active air flap (A) after loosening the mounting screws.

Install in the reverse order of removal.

Active Air Flap (AAF) Actuator

Remove the front bumper. (Refer to Body (Interior and Exterior) - "Front Bumper Cover") Disconnect the active air flap connector (A). RH LH Remove the active air flap actuator (A) after loosening the mounting screw

Cylinder Block

Cylinder Block - Components

Cylinder block Water jacket insert (Exhaust) Water jacket insert (Intake) Lower crankcase Oil jet O-ring Piston ring (No.1 ring Piston ring (No.2 ring) Piston ring(Oil ring) Piston Piston snap ring

SEE MORE:

Transmission Control Module (TCM) Inspection Procedure

Inspection Inspecting TCM ground circuit: Measure the resistance between the TCM and chassis ground. (Check the terminal connected to the chassis ground while using the back of the harness connector as the base point for TCM.) Normal

Outside rear view mirror

Component Location Outside rear view mirror Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries