Hyundai Tucson: Oil cooler pipe
- Remove the heater pipe
- Disconnect the oil cooler hose (A) from the ITM.

- Disconnect the oil cooler hose (A) from the oil cooler.

- Rmove the oil cooler pipe (A) after loosening the mounting bolts.
Tightening torque : 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

- Install in the reverse order of removal.
- Fill with engine coolant.
(Refer to Cooling System - "Coolant")
WARNING
The coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.
- Start engine and check for leaks.
READ NEXT:
Water Inlet Fitting
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
Drain the coolant.
(Refer to Cooling System - "Coolant")
Disconnect the radiator lower hose (A).
Disconn
Troubleshooting
Trouble Symptom
Coolant
leakage
From the
bleed hole of
the water
pump
From gaskets
or bolts
From outer
surface of
water pump
Probable Cause
Visually
check
Check leaks
after about
ten-minute
warming up.
If co
Active Air Flap(AAF)
Remove the front bumper.
(Refer to Body (Interior and Exterior) - "Front Bumper Cover")
Disconnect the active air flap connector (A).
RH
LH
Remove the active air flap (A) after loosening the mounting screws.
RH
SEE MORE:
Wireless smart phone charging system
[A] : Indicator light, [B] : Charging pad
On certain models, the vehicle comes
equipped with a wireless smart phone
charger.
The system is available when all doors
are closed, and when the Engine Start/
Stop button is in the ON (or START)
DPF Differential Pressure Sensor (DPS)
Description
Differential Pressure Sensor (DPS) is measure the pressure difference of EGR
inlet and outlet.
Circuit Diagram
Harness Connector
Removal
Turn the ignition swtich OFF, and then disconnect the battery negative
(-) t
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual