Hyundai Tucson: Lighting System
- Lighting System - Removal
- Head Lamp Aiming
- Outside Rear View Mirror - Removal
- Outside Rear View Mirror - Installation
- Rear Outside Combination Lamp
READ NEXT:
Lighting System - Removal
Troubleshooting
Specifications
Removal
Disconnect the negative (-) battery terminal.
Remove the front bumper assembly.
(Refer to Body - "Front Bumper Assembly")
Disconnect the head lamp connector (A).
Loo
Head Lamp Aiming
Instructions
Alternately turn the adjusting gear to adjust the head lamp aiming.
If beam-setting equipment is not available, proceed as follows:
Draw vertical lines (Vertical lines passing through respective head lamp
centers) and a horizo
Outside Rear View Mirror - Removal
Removal
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to prevent
damage to components.
Put on gloves to prevent hand injuries.
Disconnect the negative (-) battery terminal.
Remove the f
SEE MORE:
Input shaft speed sensor- Removal
Removal
Turn ignition switch OFF and disconnect the negative (-) batteiy cable.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Disconnect the electronic shift actuator connecto
Crash pad lower panel
Component
Location
Crash pad lower panel
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
