TucsonDataManu

.com

Hyundai Tucson: Outside Rear View Mirror - Removal

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Lighting System / Outside Rear View Mirror - Removal

Removal

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim.

    (Refer to Body - "Front Door Trim")

  3. Disconnect the rear view mirror connector (A).

  1. Loosen the mounting nuts and then remove the outside rear view mirror (A).

Front Turn Signal Lamp

Front Turn Signal Lamp

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front wheel guard.

    (Refer to Body - "Front Wheel Guard")

  3. Remove the turn signal lamp (A) after turning in the counterclockwise direction.

Rear Turn Signal Lamp

Rear Turn Signal Lamp

Remove

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear bumper assembly.

    (Refer to Body - "Rear Bumper Assembly")

  3. Loosen the mounting screws and remove the rear turn signal lamp (A).

  1. Remove the bulb after turning in the counterclockwise direction.

Replacement

Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Loosen the mounting clips and remove the rear side under cover (A).

  1. Remove the bulb after turning in the counterclockwise direction

Outside Rear View Mirror - Installation

    READ NEXT:

     Outside Rear View Mirror - Installation

    Outside Rear View Mirror Installation Install the outside rear view mirror and connect the connector. Tightening torque : 6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft) Connect the negative (-) batteiy terminal. Front/Rear Turn Sig

     Rear Outside Combination Lamp

    Disconnect the negative (-) battery terminal. Loosen the mounting bolts then remove the outside rear combination lamp (A). Disconnect the rear combination lamp connector (A). Remove the bulb after turning it in the counter

     Rear Occupant Alert

    Description The system detects the passenger in the vehicle and prevents the driver from getting off the vehicle with the passenger in the 1st warning: If you open the driver's door after you open and then close the rear passenger and t

    SEE MORE:

     Engine oil

    Checking the engine oil level Engine oil is used for lubricating, cooling, and operating various hydraulic components in the engine. Engine oil consumption while driving is normal, and it is necessary to check and refill the engine oil regularl

     External Control Valve Compressor Inspection (GDS)

    Compressor type: Fixed type compressor, External control valve, Internal control valve. In cases of fixed type and internal control valve, it is possible to inspect compressor's operation with clutch noise. When it comes to External con

    Information