TucsonDataManu

.com

Hyundai Tucson: Electric WGT Control Actuator- Desrcription

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Control - Fuel System / Electric WGT Control Actuator / Electric WGT Control Actuator- Desrcription

Desrcription

The Electric Waste Gate Actuator(EWGA) is installed on the turbocharger. EWGA operates vain in west gate turbocharger and controls the compressed air by PWM signal of ECM.

Specification

Specification

EWGA Position Sensor integrated into EWGA

EWGA DC Motor integrated into EWGA

EWGA DC Motor integrated into EWGA

Circuit Diagram

Circuit Diagram

Harness Connector

Harness Connector

Removal

Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the air cleaner assembly.

(Refer to Engine Mechanical System - "Air Cleaner")

  1. Remove the intercooner inlet pipe.

(Refer to Engine Mechanical System - "Intercooler")

  1. Disconnect the EWGA connector (A).

  1. Remove the shaft link assembly (B) after removing the C-ring (A).

  1. Remove the EWGA after removing the bolts (A).

Tightening Torque : 9.8 - 11.8 N.in (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Electric WGT Control Actuator- Installation

    READ NEXT:

     Electric WGT Control Actuator- Installation

    WARNING When replacing the Electric WGT Control Actuator, perform the rod adjustment procedure. When install the electric WGT control actuator, do not reuse a C-Ring. Install in the reverse order of removal. Adjustment Rod Adjus

     RCV Control Solenoid Valve

    Description RCV (Recirculation Valve) Control Solenoid Valve is installed on the intercooler inlet pipe and operates the RCV actuator which controls the by-pass passage of the turbocharger compressor.When the throttle is closed, while the engi

     Electric Exhaust Gas Re-circulation (EEGR) Control Valve

    Description The Electric EGR Control Valve is installed in between the EGR cooler and the exhaust line and is a solenoid valve. This valve controls EGR (Exhaust Gas Recirculation) amount by the ECM's duty control signal depending on engine

    SEE MORE:

     Windshield Glass - Installtion

    Installtion Using a knife, scrape the remaining sealant around the body panel leaving about 2mm-thick sealant (0.0079 in.) on the bonding surface. If installing a new windshield glass, make alignment marks on the windshield glass and th

     Manual Speed Limit Assist (MSLA)

    Manual Speed Limit Assist enabled indicator  Set speed You can set the speed limit when you do not want to drive over a specific speed. If you drive over the preset speed limit, Manual Speed Limit Assist will operate (set spe

    Information