Hyundai Tucson: Electric WGT Control Actuator
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Control - Fuel System / Electric WGT Control Actuator
READ NEXT:
Electric WGT Control Actuator- Desrcription
Desrcription
The Electric Waste Gate Actuator(EWGA) is installed on the turbocharger. EWGA
operates vain in
west gate turbocharger and controls the compressed air by PWM signal of ECM.
Specification
EWGA Position Sensor integrated into EWGA
Electric WGT Control Actuator- Installation
WARNING
When replacing the Electric WGT Control Actuator, perform the
rod adjustment procedure.
When install the electric WGT control actuator, do not reuse a
C-Ring.
Install in the reverse order of removal.
Adjustment
Rod Adjus
RCV Control Solenoid Valve
Description
RCV (Recirculation Valve) Control Solenoid Valve is installed on the
intercooler inlet pipe and
operates the RCV actuator which controls the by-pass passage of the turbocharger
compressor.When
the throttle is closed, while the engi
SEE MORE:
Inhibitor switch/ Manual control lever- Removal
Turn ignition switch OFF and disconnect the batteiy negative (-)
terminal.
Make sure vehicle does not roll before setting shift lever to "N"
position.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical
Head Lamp Aiming
Instructions
Alternately turn the adjusting gear to adjust the head lamp aiming.
If beam-setting equipment is not available, proceed as follows:
Draw vertical lines (Vertical lines passing through respective head lamp
centers) and a horizo
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
