Hyundai Tucson: Rear Wiper Washer
READ NEXT:
Rear Wiper Washer - Removal
Disconnect the negative (-) battery terminal.
Loosen the mounting nut and remove the rear wiper arm & blade (A).
WARNING
Take care not to damage the rear glass when removing the rear wiper
arms & blades.
Remove the tail gat
Automatic Stop Operation Check
Operate the motor at low speed using the stalk control.
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
Connect the positive (+) lead from the battery to terminal 3 and the
negative (-) lead to t
Multifunction Switch Inspection
Check for continuity between the terminals in each switch position as
shown below.
Inspection (With Diagnostic Tool)
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (d
SEE MORE:
Integrated memory system
The IMS, or Integrated Memory System,
for the driver's seat is equipped on some
models. This feature allows the driver
to store and recall the following position
settings with a simple button operation:
Driver's seat position
WARNING
Battery Module Inlet B Duct
Remove the 48V battery assembly.
(Refer to 48V Battery System - "Repair procedures")
Remove the battery pack assembly inlet duct B (A) after loosening the
mounting bolts.
Install in the reverse order of removal.
Sp
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
