Hyundai Tucson: Automatic Stop Operation Check
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Rear Wiper Washer / Automatic Stop Operation Check
- Operate the motor at low speed using the stalk control.
- Stop the motor operation anywhere except at the off position by disconnecting terminal 3.
- Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 1.
- Check that the motor stops running at the off position.
Diagnosis with diagnostic tool
- In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (diagnostic tool).
The diagnostic system (diagnostic tool) provides the following information.
(1) Fault Code Searching : Checking failure and code number (DTC)
(2) Data Analysis : Checking the system input/output data state
(3) Actuation test: Checking the system operation condition
(4) S/W Management: Controlling other features including system option setting and zero point adjustment
- If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and "Vehicle".
- Select the 'Data Analysis'.
- Select the 'IBU_BCM' to search the current state of the input/output data.
Removal
- Disconnect the negative (-) battery terminal.
- Remove the clock spring.
(Refer to Restraint - "Driver Airbag(DAB) and Clock Spring")
- Disconnect multifunction switch assembly connector (A).
- Remove the multifunction switch assembly (B) after loosening the clamp (A).
Installation
- Install the multifunction switch assembly.
- Install the steering column upper and lower shrouds.
- Install the steering wheel.
- Connect the negative (-) battery terminal.
Inspection
READ NEXT:
Multifunction Switch Inspection
Check for continuity between the terminals in each switch position as
shown below.
Inspection (With Diagnostic Tool)
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (d
Electro Chromic Inside Rear View Mirror
Description
Electro Chromic Inside Rear View Mirror
The ECM (Electro Chromatic inside rear view Mirror) is intended dim the
reflecting light in the rear
view mirror. The forward facing sensor detects brightness of the surroundings,
while the r
Panorama Sunroof
Component Location
Panorama sunroof
Panorama sunroof switch
Panorama sunroof motor & Controller
Roller blind motor & Slave controller
Circuit Diagram
Connector Pin Information
Removal
Disconnect the negative
SEE MORE:
Why didn't my air bag go off in a
collision?
There are certain types of accidents in
which the air bag would not be expected
to provide additional protection. These
include rear impacts, second or third
collisions in multiple impact accidents,
as well as low speed impacts. Damage to
the v
DCT (Dual Clutch Transmission) System (SBW)- Removal
Components
DCT (Dual Clutch Transmission) assembly
DCT support bracket
Roll rod support bracket
Removal
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
