Hyundai Tucson: Multifunction Switch Inspection
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Rear Wiper Washer / Multifunction Switch Inspection
- Check for continuity between the terminals in each switch position as shown below.
Inspection (With Diagnostic Tool)
- In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (diagnostic tool).
The diagnostic system (diagnostic tool) provides the following information.
(1) Fault Code Searching : Checking failure and code number (DTC)
(2) Data Analysis : Checking the system input/output data state
(3) Actuation test: Checking the system operation condition
(4) S/W Management: Controlling other features including system option setting and zero point adjustment
- If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and "Vehicle".
- If check current status, select the "Data Analysis" and "Car model".
- Select the 'IBU_BCM' to search the current state of the input/output data.
Inspection
- With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
WARNING
Before filling the reservoir tank with water, check the filter for foreign material or contamination, if necessary, clean the filter.
- Connect positive (+) and negative (-) battery cables to terminals 3 and 1 respectively to see that the washer motor runs and water is pumped.
- Check that the motor operates normally.
Replace the motor if it operates abnormally.
Removal
WARNING
- Provides a service position for blade removal with hidden rear wiper.
- The position of the wiper blade service position operates front and rear.
- After starting OFF, hold the MIST switch for 2 seconds.
WARNING
- Perform the operation within 20 seconds after starting OFF.
- The wipers rotate 0.7s and move to the service position.
- Remove the wiper blade (A) by pulling it in the direction of the arrow.
Installation
- Istall the wiper blade.
- When the wiper MIST is activated after starting ON, the wiper returns to its original position.
READ NEXT:
Electro Chromic Inside Rear View Mirror
Description
Electro Chromic Inside Rear View Mirror
The ECM (Electro Chromatic inside rear view Mirror) is intended dim the
reflecting light in the rear
view mirror. The forward facing sensor detects brightness of the surroundings,
while the r
Panorama Sunroof
Component Location
Panorama sunroof
Panorama sunroof switch
Panorama sunroof motor & Controller
Roller blind motor & Slave controller
Circuit Diagram
Connector Pin Information
Removal
Disconnect the negative
SEE MORE:
Tires and wheels
WARNING
Tire failure may cause loss of
vehicle control resulting in an
accident. To reduce risk of SERIOUS
INJURY or DEATH, take the
following precautions:
Inspect your tires monthly for
proper inflation as well as wear
and damage.
&nb
Shift gear
Components
Shift lever knob & boots assembly
Shift lever assembly
Shift cable
Manual control lever
Shift cable retainer
Removal
Turn ignition switch OFF and disconnect the negative (-) batteiy cable.
Remove the air cleane
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual