Hyundai Tucson: Rear Wiper Washer - Removal
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Rear Wiper Washer / Rear Wiper Washer - Removal
- Disconnect the negative (-) battery terminal.
- Loosen the mounting nut and remove the rear wiper arm & blade (A).
WARNING
Take care not to damage the rear glass when removing the rear wiper arms & blades.
- Remove the tail gate trim.
(Refer to Body - "Tailgate Trim")
- Disconnect the motor connector (A).
- Loosen the mounting bolts and remove the rear wiper motor assembly (A).
Installation
- Install the rear wiper motor assembly.
Tightening torque Nut: 6.9 - 9.8 Nm (0.7 - 1.0 kgf.m. 5.0 - 7.2 lbf.ft)
- Install the tail gate trim.
- Install the rear wiper arm cap after tighting the nut.
Tightening torque Nut: 8.8 - 12.7 N.m (0.9 - 1.3 kgf.m, 6.5 - 9.4 Ib.ft)
- Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
Inspection
- Remove the connector from the rear wiper motor.
- Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
- Check that the motor operates normally. Replace the motor if it operates abnormally.
READ NEXT:
Automatic Stop Operation Check
Operate the motor at low speed using the stalk control.
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
Connect the positive (+) lead from the battery to terminal 3 and the
negative (-) lead to t
Multifunction Switch Inspection
Check for continuity between the terminals in each switch position as
shown below.
Inspection (With Diagnostic Tool)
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (d
Electro Chromic Inside Rear View Mirror
Description
Electro Chromic Inside Rear View Mirror
The ECM (Electro Chromatic inside rear view Mirror) is intended dim the
reflecting light in the rear
view mirror. The forward facing sensor detects brightness of the surroundings,
while the r
SEE MORE:
Battery Condition - Vehicle parasitic current inspection
Inspection
Check the battery for damage or deformation. If severe damage, deformation or
leakage is found, replace the
battery.
Using the Ammeter
Turn the all electric devices OFF, and then turn the ignition switch OFF.
Close all doors exc
High Pressure Fuel Line- Installation
Install in the reverse order of removal.
Install the high pressure fuel pipe as follows.
(1) Completely pre-tighten the both side nuts (A) on high pressure tightening
area of high pressure fuel pipe
while keeping them vertically.
(2) Ti
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
