TucsonDataManu

.com

Hyundai Tucson: Interior  Antenna

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Smart Key System / Interior  Antenna

Interior 1 Antenna

Take care not to scratch the crash pad and related parts.

  1. Disconnect the negative (-) battery terminal.
  2. Remove the ecall unit.

    (Refer to Emergency Call system - "Emergency Call (eCall) Unit")

  3. Remove the interior 1 antenna (B) after loosening mounting screws and disconnect the connector (A).

Interior 2 Antenna

Interior 2 Antenna

  1. Disconnect the negative (-) battery terminal.
  2. Remove the console floor console assembly.

    (Refer to Body - "Floor Console Assembly")

  3. Remove the interior 2 antenna (B) after loosening mounting screws and disconnect the connector (A).

Tailgate Antenna

Tailgate Antenna

  1. Disconnect the negative (-) battery terminal.
  2. Remove the luggage mat (A).

  1. Remove the luggage floor tray (A).

  1. Loosen the mounting clips and remove the rear transverse trim (A)

  1. Remove the tailgate antenna (B) after loosening mounting screws and disconnect the connector (A).

Exterior Bumper Antenna

    READ NEXT:

     Exterior Bumper Antenna

    Disconnect the negative (-) battery terminal. Lift the vehicle. Disconnect the antenna connector (A) from the rear bumper. Remove the antenna (B) after loosening mounting nuts. Buzzer Disconnect the negative (-) battery terminal.

     Door Outside Handle

    When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. Remove the door outside handle cover (A) Remove the plug ho

     Keyless Entry And Burglar Alarm

    Description Burglar Alarm State (B/A State) Remark: On Smart key system, it works the same way with passive lock Remark: On Smart key system, it works the same way with passive unlock Remark: On Smart key system, it works

    SEE MORE:

     Heater - Inspection

    Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : Entering (1) Set the mode to FLOOR. (2) Set the temperature to MAX HOT. (3) Turn off the blower switch. (4) Press the intake (recirculat

     Front pillar trim

    Component Location Front pillar trim Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. WA

    Information

    2022-2026 © - www.tucsondatamanu.com