Hyundai Tucson: Steering wheel - Reassembly
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Steering System / Steering wheel / Steering wheel - Reassembly
Reassembly
- To reassembly, reverse the disassembly procedure.
Installation
- To install, reverse the removal procedures.
Description
Heated pads to grip the steering grip makes the fever.
Heated pad
Specifications
System Circuit Diagram
Terminal Function
Removal
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
- Disconnect the floor console upper cover switch connector (A).
- Remove the floor console upper cover switch (A) after loosening the mounting screw.
READ NEXT:
Heated Steering Wheel Control Module (Integrated Body Control Unit (IBU)
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
Remove the glove box.
(Refer to Body - "Glove Box")
Remove the heater control unit.
(Refer to Heating,Ventilation And Air Conditioning - "Hea
Motor Driven Power Steering - Description
Description
MDPS (Motor Dirven Power Steering) system uses an electric motor to assist
the steering force and it
is an engine operation independent steering system.
MDPS control module controls the motor operation according to information
re
SEE MORE:
Low Pressure Fuel Line
WARNING
Be careful not to damage the parts located under the vehicle (floor
under cover, canister, fuel tank) when
raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
Release the residua
Tail Gate Window Glass - Removal
Removal
WARNING
Put on gloves to prevent hand injuries.
WARNING
Use seat covers to avoid damaging any surfaces.
Remove the tailgate trim.
(Refer to Tail Gate - "Tail Gate Trim")
Remove the rear spoiler.
(Refer to Body Side
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
