Hyundai Tucson: Injector
READ NEXT:
The GDI injector is similar to a standard injector, but sprays fuel at a much
higher pressure directly
into the combustion chamber and has a swirl disc to get the fuel swirling as it
exits the nozzle. This
aids in atomization of the fuel.
Th
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1. Remove the combustion seal (A) with a wire cutter.
WARNING
Grip the sealing ring carefully, pull it to form a small loop
and t
Description
Differential Pressure Sensor (DPS) is measure the pressure difference of EGR
inlet and outlet.
Circuit Diagram
Harness Connector
Removal
Turn the ignition swtich OFF, and then disconnect the battery negative
(-) t
SEE MORE:
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
Remove the floor under cover front RH.
Disconnect the Exhaust Gas Temperature Sensor (EGTS) Front (A) and Rear
(B).
Remove the gasoline particulate fil
Smart
Connect the DLC cable of diagnostic tool to the data link connector (16
pins) in driver side crash pad lower panel, turn the
power on diagnostic tool.
Select the 'S/W Management' and 'Car model'.
Select the
Injector - Description
