Hyundai Tucson: Heater
- Heater unit assembly
- Heater - Replacement
- Heater - Inspection
- Driver side temperature control actuator / Passenger side temperature control actuator
- Mode control actuator
- Auto defogging actuator
READ NEXT:
Heater unit assembly
Component Location
Heater unit assembly
Components
Heater unit assembly
Heater core cover
Heater core assembly
Mode control actuator LH
DEF duct seal
Evaporator assembly
Flange seal
Heater NVH pad
Temperature contro
Heater - Replacement
Disconnect the negative (-) battery terminal.
Recover the refrigerant with a recovery/recycling/charging station.
(Refer to Air conditioning System - "Repari procedures")
When the engine is cool, drain the engine coolant from the r
Heater - Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
Entering
(1) Set the mode to FLOOR.
(2) Set the temperature to MAX HOT.
(3) Turn off the blower switch.
(4) Press the intake (recirculat
SEE MORE:
Starter Brush Holder Test
Check that there is no continuity between the (+) brush holder (A) and
(-) plate (B). If there is continuity,
replace the brush holder assembly.
Inspect Overrunning Clutch
Slide the overrunning clutch along the shaft.
Replace i
IMT System Actuator- Replacement
iMT system actuator fluid - when fluid suction tool is available
Remove the air cleaner assembly and the air duct.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the reservoir cap (A) and drain the imt system actuator
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual