Hyundai Tucson: Clutch Cover And Disc
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Clutch Cover And Disc
READ NEXT:
Clutch Cover And Disc- Removal
Remove the manual transaxle assembly.
(Refer to In case by Gasoline 1.6 T-GDI System - "Manual Transaxle")
(Refer to In case by Diesel 1.6 TCI System - "Manual Transaxle")
(Refer to In case by Gasoline 2.0 MPI System - &qu
Clutch Cover And Disc- Installation
Apply grease on a disc spline part and transaxle input shaft spline part
as required.
Specified grease : CASMOLY L9508
Amount:
0.1 - 0.2g Gasoline 2.0 MPI / Gasoline 1.6 T-GDI
0.1 - 0.3g Diesel 1.6 TCI
Possible problems when not followin
SEE MORE:
Starter Brush Holder Test
Check that there is no continuity between the (+) brush holder (A) and
(-) plate (B). If there is continuity,
replace the brush holder assembly.
Inspect Overrunning Clutch
Slide the overrunning clutch along the shaft.
Replace i
Intake actuator
Components
Intake actuator
Inspection
Turn the ignition switch OFF.
Disconnect the intake actuator connector.
Verify that the intake actuator operates to the fresh air position when
connecting 12V to terminal 3 and grounding ter
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
