Hyundai Tucson: Center side airbag (CSAB)
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Restraint / Airbag Module / Center side airbag (CSAB)
Components Location
- Center side airbag (CSAB)
Removal
- Disconnect the batteiy negative terminal.
WARNING
After disconnecting the cables, wait at least 3 minutes.
- Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
- Loosen the CSAB mounting nuts and remove the CSAB module (A).
Tightening torque : 5.9 - 7.8 N.m (0.6 - 0.8 kgf.m, 4.3 - 5.8 lb-ft)
Installation
- Install in the reverse order of removal.
- After installing the airbag module, confirm proper system operation.
WARNING
Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.
READ NEXT:
Airbag Disposal
When you scrap a vehicle equipped with an airbag, you must deploy it first.
When you deploy an airbag, you need to have a skilled mechanic do the work. The
used airbag should
not be reinstalled in another vehicle for reuse.
WARNING
Upon de
Seat Belt Pretensioner
Description
The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH).
When a vehicle
crashes with a certain degree of frontal impact, the pretensioner seat belt
helps to reduce the severity of
injury to the front seat
SEE MORE:
Smart Cruise Control Settings
Setting features
To turn on the Smart Cruise Control
Press the Driving Assist ( ) button
to turn on Smart Cruise Control. The
speed will be set to the current speed
on the cluster.
If there is no vehicle in front of you,
the
Clutch Cover And Disc- Installation
Apply grease on a disc spline part and transaxle input shaft spline part
as required.
Specified grease : CASMOLY L9508
Amount:
0.1 - 0.2g Gasoline 2.0 MPI / Gasoline 1.6 T-GDI
0.1 - 0.3g Diesel 1.6 TCI
Possible problems when not followin
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
