Hyundai Tucson: Front View Camera System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Advanced Driver Assistance System (ADAS) / Front View Camera System
- Blcok Diagram
- System operation
- Front View Camera System - Variant Coding
- Front View Camera System - Removal
READ NEXT:
Blcok Diagram
Description and
Operation
Blcok Diagram
WARNING
This system monitors the driving situations through the radar and
the camera. Thus, for a situation out of the sensing
range, the system may not normally operate.
The System may be limited when
System operation
Front camera operating speed by each system :
The operating conditions of the front camera are as follows when the USM of
the following system is ON and the required operating speed is satisfied.
FCA, Forward Collision-Avoidance Assist
Front View Camera System - Variant Coding
Components Location
Front camera
Speaker (Cluster)
Variant Coding
WARNING
When you need variant coding:
Replace Front View Camera with a new one
* EOL Variant Coding and calibration required for new replacement
Front View Camer
SEE MORE:
Engine And Transaxle Assembly - Removal and Installation
Remove the engine cover (A).
Installation is reverse order of removal
Removal and
Installation
Front Under Cover
Remove the engine room under cover (A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
Rear View Monitor (RVM)
Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift
lever in the R position.
This system is a supplemental system that shows behind the vehicle through the
H/UNIT or the ECM
(Reve
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
