Hyundai Tucson: Control Cable - Removal
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Intelligent Manual Transaxle (IMT) System / Control Cable / Control Cable - Removal
- Turn OFF ignition switch and disconnect the negative (-) batteiy cable.
- Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
- Remove the batteiy and batteiy tray.
(Refer to Engine Electrical System - "Battery")
- Remove the control cable.
(1) Remove the snap pin (A).
(2) Separate the select cable (B) and then shift cable (C).
- Remove the shift lever.
(Refer to Manual Transaxle Control System - "Shift Lever")
- Loosen the nuts (A) and then removing the control cable retainer (B).S
- Remove the control cable from vehicle.
READ NEXT:
Control Cable- Installation
Installation
WARNING
Check if the 4th fixing pin (A) is installed.
Install the control cable retainer (B) and then tightening the nuts (A).
Tightening torque:
11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)
Install the clip, i
Control Shaft Complete
Components and Components Location
Control shaft complete
Description
-Component location : Control shaft complete is mounted on the top of
the manual transaxle, and
select & shift cable are equipped.
Function : Change the g
SEE MORE:
Fuel Filler Door
Component Location
Fuel filler door
Replacement
Fuel filler door cover
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to preve
DCT (Dual Clutch Transmission) System (SBC) - Installation
Installation
To install, reverse the removal procedure.
WARNING
Matters that require attention when installing the dual clutch
transmission (DCT) to engine
l)Check the pilot bearing (B) and external damper (A) on the side of
engine for a
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
