Hyundai Tucson: Control Cable
READ NEXT:
Control Cable - Removal
Turn OFF ignition switch and disconnect the negative (-) batteiy cable.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the batteiy and batteiy tray.
(Refer to Engine E
Control Cable- Installation
Installation
WARNING
Check if the 4th fixing pin (A) is installed.
Install the control cable retainer (B) and then tightening the nuts (A).
Tightening torque:
11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)
Install the clip, i
Control Shaft Complete
Components and Components Location
Control shaft complete
Description
-Component location : Control shaft complete is mounted on the top of
the manual transaxle, and
select & shift cable are equipped.
Function : Change the g
SEE MORE:
On vehicle inspection
Inspection
Accelerate the engine to about 3,000 rpm 3 times or more.
Remove the spark plug.
(Refer to Spark Plug - "Removal")
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the
Troubleshooting
WARNING
1) After replacing controller, always check that the system operates
properly.
2) If the failure persists after replacing the controller, do not
replace the controller.
Inspection by DTC Code
Inspection for Defect in S
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
