Hyundai Tucson: Blower
READ NEXT:
Blower unit assembly
Components Location
Blower unit assembly
Components
Blower unit assembly
Intake actuator
Intake duct case LH
Intake seal
Intake door(l)
Intake door(2)
Intake duct case RH
Climate control actuator
PWM blower module
B
Blower - Replacement
Disconnect the negative (-) battery terminal.
Recover the refrigerant with a recovery/recycling/charging station.
(Refer to Air conditioning System - "Repari procedures")
When the engine is cool, drain the engine coolant from the r
Blower - Inspection
Connect the battery voltage and check the blower motor rotation.
If the blower motor does not operate well, substitute with a known-good
blower motor and check
for proper operation.
Replace the blower motor if it is proved that th
SEE MORE:
Tires_Wheels - Installation
Installation
Apply tire soap or lubrication to the top and bottom tire beads.
WARNING
When changing the wheel, do not reuse the snap-in type TPMS sensor.
To fit the bottom bead, position the valve at the 5 o'clock position
rela
Airbag Module - Removal
Removal
Set the front tires straight-ahead.
Disconnect the batteiy negative terminal.
WARNING
After disconnecting the cables, wait at least 3 minutes.
Put a flat tool (05mm) into a guide hole located in the left/right of
steering whe
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
