Hyundai Tucson: Specifications
IMT system actuator
Gear position sensor
Gear position sensor select lever - signal code table
Speed sensor
IMT system actuator fluid
Tightening Torques
Lubricants
Sealant
Special Service Tools
Tool (Number and Name)/ Illustration/ Use
09200-3N000
Engine support
fixture (Beam) 
Removal and
installation
of the transmission.
Use this beam (SST No. : 09200-3N000) with the supporter (SST No. : 09200-2S200).
09200-2S200
Engine support
fixture (Supporter) 
Removal and
installation
of the transaxle.
with the beam (SST No. : 09200-3N000).
09200-L1200
Engine support
fixture (Front) 
Removal and
installation
of the transaxle.
with the beam (SST No. : 09200-3N000).
09200-4X000
Engine support
fixture
(Adapter) 
Removal and installation
of the transaxle.
Use this beam (SST No. : 09200-3N000)
09453-2F300
Oil seal installer 
Installation of
transaxle
case oil seal. 2WD
09473-D3500
Oil seal installer 
Installation of
transaxle
case oil seal. 4WD
READ NEXT:
Troubleshooting
Trouble symptom/ Suspected area/ Remedy
Abnormal noise
Oil level (Low)
Add oil after inspecting the
parts, (oil seal, drain plug, filler
plug)
Oil (Wrong or contaminated)
Replace the oil.
Transaxle and engine mounting
Intelligent Manual Transaxle (IMT)
Components and Components Location
Clutch housing
Gear position sensor
IMT system actuator
Control shaft complete
Transaxle bracket
Control cable bracket
Removal
Remove the air cleaner assembly and air duct.
(Refer to Engi
Intelligent Manual Transaxle (IMT) Oil
General
Information
Check & Change intervals
WARNING
Severe usage is defined as
Driving in dusty, rough roads
Driving in areas using salt or other corrosive materials or in
very cold weather
Driving in sandy areas
Drivin
SEE MORE:
Blcok Diagram
Description and
Operation
Blcok Diagram
WARNING
This system monitors the driving situations through the radar and
the camera. Thus, for a situation out of the sensing
range, the system may not normally operate.
The System may be limited when
Differential Carrier Assembly - Reassembly
Reassembly
Pinion drive gear assembly
Install the inner pinion bearing adjustment shim (A) 011 the pinion
drive gear assembly.
Install the inner pinion bearing (A) on the pinion drive gear using SST
(0K530-P2200) and press.
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
