Hyundai Tucson: General Information
READ NEXT:
Specifications
IMT system actuator
Gear position sensor
Gear position sensor select lever - signal code table
Speed sensor
IMT system actuator fluid
Tightening Torques
Lubricants
Sealant
Special Service Tools
Tool
(Numb
Troubleshooting
Trouble symptom/ Suspected area/ Remedy
Abnormal noise
Oil level (Low)
Add oil after inspecting the
parts, (oil seal, drain plug, filler
plug)
Oil (Wrong or contaminated)
Replace the oil.
Transaxle and engine mounting
Intelligent Manual Transaxle (IMT)
Components and Components Location
Clutch housing
Gear position sensor
IMT system actuator
Control shaft complete
Transaxle bracket
Control cable bracket
Removal
Remove the air cleaner assembly and air duct.
(Refer to Engi
SEE MORE:
Steering wheel - Disassembly
Disassembly
Loosen the paddle shift switch mounting screw (A).
Remove the paddle shift switch (A) after disconnecting the connector.
Remove the lower cover (A) after loosening the screw.
Disconnect the wiring
Automatic Stop Operation Check
Operate the motor at low speed using the stalk control.
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
Connect the positive (+) lead from the battery to terminal 3 and the
negative (-) lead to t
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
